Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Homestead?
Spring repair in Homestead typically costs $180 – $340 for a single torsion spring, and most jobs are finished in one visit once we’ve confirmed the right wire gauge and length for your door. If both springs are worn, a matched pair runs about twice that range, so budget roughly $360 – $680 for the pair. You’ll get a written estimate before any work starts, and that estimate sets the final price.
Key Takeaways
- One spring: roughly $180 – $340. A matched pair: about $360 – $680, because pairs are replaced together for even lift.
- Coil count, wire size, door weight and ceiling height move the number more than anything else.
- Don’t run the opener with a broken spring. It can bend the top section or burn out the motor.
- Estimates are free. Call (844) 497-0861. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Spring Replacement Cost Breakdown (2026)
Here’s how the money typically breaks down on a home in Homestead. These are estimated ranges for 2026, and the written estimate you receive is the price you pay.
| Work | Typical Estimated Range |
|---|---|
| Torsion spring replacement (one spring) | $180 – $340 |
| Matched pair of torsion springs | About $360 – $680 |
| Extension spring replacement (per spring) | $180 – $340 |
| Lift cables replaced at the same time | $130 – $250 |
| Roller replacement while we’re in the door | $110 – $220 |
| Track realignment | $120 – $240 |
| Opener repair if the motor was strained | $120 – $320 |
| Panel replacement for a bent section | $250 – $500 |
| Full garage door repair when several parts fail together | $150 – $600 |
| New door installation, if the door itself is done | $700 – $2,200 |
What pushes a job toward the top of the spring range? Heavier doors, high-lift setups where the door tracks up close to the ceiling, and any extra parts that come due at the same time. Cables and springs wear on the same clock, so replacing a frayed cable while the tension is already off costs less than a second visit later. Rusted or seized drums add labor. A door with a cracked end plate usually needs that plate dealt with before new springs go on, since the spring anchors to it.
What keeps a job at the low end? A standard seven-foot door with clean, accessible hardware and springs that come out without a fight. Most single-car doors fall here. Two-car doors with a pair of springs sit in the middle.
What Affects Spring Replacement Pricing in Homestead
- Spring type and coil count. A torsion spring mounted above the door and an extension spring running along the track are different jobs with different hardware. Heavier doors need thicker wire and more coils, and that costs more.
- Door weight and material. A single steel door is lighter than a double door with insulation or a wood-look face. Spring sizing follows the weight, so a heavier door means larger springs.
- Ceiling height and clearance. Homes in Homestead vary from standard garages to taller setups with high-lift tracks. When the door travels higher, the spring has to be sized for it and the work takes longer.
- Access and heat. A garage that’s been closed up in the South Florida sun gets genuinely hot inside, so we plan the job with that in mind. A clear path to the door and a reasonably uncluttered workspace keep labor down.
- Condition of cables, drums and end plates. Springs rarely fail alone on an older door. If a cable is frayed or a drum is worn, it’s cheaper to handle it in the same visit than to come back.
- Age of the door and opener. A door that has been running on tired springs puts strain on the opener. If the motor has been working against a slack spring, an opener repair or a roller swap may be on the same bill.
How to Save on Spring Replacement
The single biggest saver is catching the problem before it snaps. A spring that’s stretched or has a visible gap between coils is on its way out. Replacing it on a planned visit is simpler than dealing with a door stuck shut or, worse, a car trapped inside.
- Replace the pair, not one. Two springs installed at the same time wear at the same rate and lift evenly. A single fresh spring next to an old one takes more of the load and tends to fail first.
- Bundle related parts. If the cables, rollers or a drum are near the end of their life, adding them to the spring visit costs less than a separate call. See what our spring replacement service covers.
- Stop using the opener. Running the motor against a broken spring can bend a panel or burn out the gear. That turns a spring job into a panel replacement or an opener repair.
- Get the estimate in writing first. A clear written estimate tells you exactly what’s included. Estimates are free, so there’s no reason to guess. Call (844) 497-0861 to set one up.
- Ask about the door’s overall condition. If the door is old and patched, it helps to know what full replacement would cost before you spend on repairs. We handle installations too, so you get both numbers in one conversation.
Can You Replace a Broken Spring the Same Day?
Yes, in most cases. Spring replacement is one of the jobs we handle every week, and we keep common spring sizes and hardware ready for the visit. When your door won’t budge, call and we’ll book the soonest opening. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Springs are the most dangerous part of a garage door system. The torsion spring above the door holds the full weight of the door under heavy tension, and a cable or spring that lets go can cause serious injury. That’s why we don’t recommend adjusting or removing springs yourself. Our technicians have up to 9 years of experience with this work, and the local pro we connect you with is licensed and insured as Florida requires.
We work with the major brands you’re likely to have on your door: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. Knowing the brand up front means the technician arrives with the right hardware and the right spring sizing for your door rather than making a second trip.
Is It Cheaper to Repair the Spring or Replace the Door?
Repairing the spring is almost always cheaper. A spring job runs $180 – $340 for one spring, while a new door installation starts at $700 and can reach $2,200. Replacement only makes sense when the door itself is failing: cracked panels, a bent track that won’t straighten, or a door that has rusted through.
Here’s a plain way to decide. If the door panels are sound and the only problem is the spring, repair it. If two or more panels are damaged, or the door has been hit by a car and the track and panels are both bent, put the money toward a new door. Our Homestead Garage Door Repair Pros team can look at both options on the same visit so you’re not comparing prices from two different contractors. If the door needs a full swap, panel replacement ($250 – $500) or a complete installation ($700 – $2,200) are the two paths.
Why Do Springs Fail in South Florida?
Heat and humidity are the main culprits. A garage in Homestead spends most of the year at high temperatures, and that cycles the steel in the spring thousands of times. Springs are rated in cycles, not years, and every open and close uses one up. A busy household that runs the door several times a day will wear through a spring faster than one that uses it twice.
Humidity also works on the surrounding hardware. Cables, drums, hinges and rollers pick up surface rust, which adds friction and makes the spring work harder. A door that’s been squeaking or jerking is telling you something is binding. That’s worth a look before the spring takes the strain. The fix is often a roller replacement ($110 – $220) or a track realignment ($120 – $240) rather than a spring.
What Happens When You Call
You tell us what the door is doing: won’t open, hanging halfway, or a loud bang from the garage. We ask for the brand and roughly how wide the door is, which lets us bring the right hardware. Then we book a time that works. Fast dispatch from 7am to 7pm, Sunday through Friday.
On the visit, the technician checks the springs, cables, drums, rollers and track, then gives you a written estimate. No work starts until you approve it. If it turns out the problem isn’t the spring at all, we’ll tell you that too. A door that won’t close can be a photo-eye or opener issue (opener repair runs $120 – $320), and a door that’s off its track is a realignment job, not a spring.
FAQs – Spring Replacement Cost
How much does garage door spring replacement cost in Homestead?
Spring replacement in Homestead typically costs $180 – $340 for one spring, and about $360 – $680 for a matched pair. The written estimate sets the final price. Call (844) 497-0861 for an exact quote. Estimates are free.
Do I need to replace both springs at once?
In most cases yes, and the pair costs roughly twice the single-spring range, so $360 – $680. Springs installed together wear at the same rate. A single new spring beside an old one carries more of the load and tends to fail first. Call (844) 497-0861 and we’ll tell you what your door needs.
Can you come today if my garage door won’t open?
Usually yes. A door stuck open or shut is a same-day priority, and a broken spring is one of the most common reasons a door stops moving. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Call (844) 497-0861.
Is it cheaper to repair the spring or replace the whole door?
Repairing the spring is far cheaper: $180 – $340 against $700 – $2,200 for a new door. Replacement only makes sense when the panels or track are failing too. Call (844) 497-0861 and we’ll give you both numbers in writing.
How long does a spring replacement take?
A typical single-spring job takes about an hour once the technician is on site, and a pair takes a bit longer. Most visits are done in one trip. If cables or rollers need attention too, add some time. Call (844) 497-0861 for a free estimate and a clear window.
Contact Us for a Free Spring Replacement Estimate
If your door won’t budge, don’t force it. A broken spring is a safety issue, not a job to put off until next week. Call (844) 497-0861 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We work with your brand, handle the repair and the installation side both, and give you a written price before anything starts. When your garage door won’t budge, one call is all it takes to get a straight answer on cost.
Pricing reflects the Homestead market as of 2026. Homestead Garage Door Repair Pros offers free estimates – call (844) 497-0861.
Written by the team at Homestead Garage Door Repair Pros.
What Our Customers Say
"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Craig Schaefer"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Carmen Castillo"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Lisa Lawson